Automašīnas dūmu mašīnas ātrās ieplūdes adaptera ieplūdes pūslis dūmu noplūdes detektoram SDT206 diagnostikas rīks, gaisa spilvena piederums

Pear for Smoke Generator Quick Seal Intake AdaptorAttention:1. Please make sure the diameter of intake/exhaust is greater than2 2. Please Clean the inner wall of the pipeline before insert the inflatable adapter, so as not to scratch the adapter. 3. This item is not chimney generator, it s additional for chimney generatorMaximum diameter after inflation : 11cm /4.33 inchOBDResource Pear for Smoke Generator:●Quick Seal Intake Adaptor is an inflatable block off bladder with a pressurized vapor pass-through that allows technicians to test an entire intake or exhaust systems quickly and easily. ●Quick Seal Intake Adaptor can be used with any brand of smoke machine or diagnostic leak detector to reduce workload on a leak check. ●Block off bladder conforms to any shape of intake / exhaust: Round, oval, square, rectangular and even severely angled and hard to reach intake / exhaust systems, while allowing vapor to pass through for fast diagnostics. ●Compatible with any smoke machine, It fits 100% of automobiles, from passenger car to heavy-duty trucks, to quickly leak test the integrity of the entire induction system with one simple procedure.OBDResource Pear for Smoke Generator Advantages:●Fit most cars and light trucks ●Quick seal intake/exhaust easily ●Reduce workload in a leak check ●Fits any shape of intake/exhaust (diamter greater than 2 ) :round,oval,square,rectangular and even severelly angled and hard to reach intake/exhaust systems ●Work with any brand of smoke machine or diagnostic leak detectorsPear for Smoke Generator Instruction:1) Clean the inner wall of the intake opening while the Air Filter, and the Throttle connections are removed,so as not to scratch the adapter. 2) Close the Pressure Relief Valve(A) next to the Hand Pump(B). 3) Put the Rubber Component(C) into the intake opening. 4) Inflate the Rubeber Component(C) by pressing the Hand Punm(B) till the intake opening is tightli sealed. 5) Now the system is ready to test,introduce air/smoke into the system by plug the smoke nozzle into the Tube Opening(D). 6) After test,pull off the smoke nozzle,release the inflated air by open the Pressure Relief Valve(A) next to the Hand Pump(B). 7) Clean the adapter for storage,avoid contact with corrosive liquids.Packing List:1pc * OBDResource Quick Seal Intake Adaptor Pear for Smoke Generator